MGP WRM2 Specifikace Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 58
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
TelePole WR/ Operating & Maintenance Manual Page 12
3.5. Alarms
a. Detector alarm: The Err. LCDs and SPK icon will blink on the display in three cases:
1. The detector is disconnected.
2. The detector high voltage power supply is defective.
3. The detector is located in a background radiation field < 600 mR/h and the low range
Geiger is defective.
4. If the detector is located in a radiation field higher than 800 mR/h and the meter displays
the following sequence of readings: 800 mR/h, 600 mR/h, 0.00 mR/h - this indicates the high
range geiger is malfunctioning.
Note: It is recommended to check the meter and the detector with a calibration source, to
ensure correct operation. Check:
Background field during two minutes,
50 mR/h for the low range Geiger,
5.00 R/h for the high range Geiger.
To mute the audible alarm, press the RESET push-button.
b. Battery alarm: If battery voltage decreases below 2.2V, the battery and SPK icons blink
on the display, and an interrupted audible alarm is activated.
To mute the audible alarm, press the RESET push-button.
c. Overflow alarm: If the displayed Exposure rate is over 999 R/h, the O.F. LCDs and SPK
icon will blink on the display and an interrupted audible alarm will be activated. To mute the
audible alarm, press the RESET push-button.
d. Threshold alarm for Exposure rate: If the Exposure rate reading exceeds threshold value,
the RATE LCDs and SPK icon will be displayed, accompanied by an audible beep.
Pressing the RESET push-button mutes the audible alarm, but the RATE LCDs, the SPK
icon and the reading continue to be displayed, until the reading decreases to 75% of threshold
value. In case the reading exceeds threshold value and then decreases to below 75% of the
threshold value, the RATE LCDs, the SPK icon and the beep sound will automatically
cancel, even though the RESET push-button has not been pressed.
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Komentáře k této Příručce

Žádné komentáře